Error BIE | 1955D BIE

[joel]

This BIE is also an RPM. It has a minor lower split. I was unable to find it listed. Thanks for looking.

[JC Stevens]

Nice BIE..

[jfines69]

Nice find... Did you post the RPM???

[joel]

I'll try to get a pic of split Jim and then I will post it. Thanks. Larry

[ray_parkhurst]

I don't know of a 1955-D RPM that ended with a BIE so am very interested to see it.

[joel]

Thanks all for checking it out! I can't capture the split on the lower serif with my camera. If someone would like to capture it I would be pleased to mail it to you. Larry

[jfines69]

I am always up for the task Larry!!!

[joel]

Thanks Jim! I'll put it in the mail to you. Larry

[jfines69]

55D BIE with RPM

I have pics of Larrys 55D BIE with RPM. The BIE looks to be COCs LDB4-1955D-067 4EL+... The listed sample is worn but both have the little tail at the bottom of the BIE and are on the Es upper horizontal bar... I zoomed in on the date/MM of the listed BIE but it is difficult to tell if the MM position matches as the listed samples 1st 5 has damage to the tail but the MM looks to be in position at the 9... Also Larrys has a pre cud (unlisted) on the left wheat and the crack may be there on the listed sample but is difficult to tell for sure... I can see that the 1st dot of EPU looks worn on the sample as is on Larrys coin!!!

Now the RPM!!!

[jfines69]

Larrys 55D BIE with RPM

Larrys BIE looks to have an unlisted tilted RPM... I did not find it on CC, VV or Wexlers (may not be posted yet)... It is a little difficult to see the separation lines on the MMs horizontal bars due to the circ wear and damage (3rd MM close up) when looking straight down but they are there. I put some pointers for the notches (2nd MM close up) which should help in following the separation lines... There are some heavy die flow lines that can be seen on numerous pics... I pointed out cracks in the hair that have circ wear that made them difficult to see!!!

[joel]

Thanks Jim!! You always go above and beyond. Not only did you confirm the splits but you identified the BIE listing. Thank you very much!! Larry

[jfines69]

You are very welcome... Always glad to help you out... I will have it back into the mail to you tomorrow!!!

[Sheila ruley]

Larrys BIE looks to have an unlisted tilted RPM... I did not find it on CC, VV or Wexlers (may not be posted yet)... It is a little difficult to see the separation lines on the MMs horizontal bars due to the circ wear and damage (3rd MM close up) when looking straight down but they are there. I put some pointers for the notches (2nd MM close up) which should help in following the separation lines... There are some heavy die flow lines that can be seen on numerous pics... I pointed out cracks in the hair that have circ wear that made them difficult to see!!!

. That’s absolutely incredible!!!!!!

[duck620]

found quite a few of BIE LINCOLN'S.

[joel]

Jim, Your help and pics are greatly appreciated! Larry